HDMI CABLE EXTENDERS This uses power from the HDMI bus to repeat the signal, therefore no external power supply is required. It allows cable runs to be extended up to 30 metres, according to cables used. It also can permit smaller gauge HDMI cables to be used, thus making installations easier in confined spaces. The … Continue reading "HDMI CABLE EXTENDER"

TELEGARTNER BNC CONNECTORS – Male, cable – Crimp – 3G HD-SDI These high-performance, 75 ohm types, from a leading German manufacturer, have been developed specifically for applications up to 3G HD. They have extremely low return loss, and are rated to 1000 mating cycles. The impedance-matched, gold-plated crimp centre-pin ‘clicks’ home into a PTFE insulator … Continue reading "TELEGARTNER BNC 3G HD Male cable, crimp, 75 ohm, group J"

ENCLOSURE SYSTEMS 262T SERIES RACK CABINETS – Fully assembled The 262T Series is a competitively priced range of floor-standing 19 inch steel framed racks, available in two widths and three depths, supplied fully assembled (also available flat packed). Sides and doors to the front and rear may be removed for access. The cabinets are supplied … Continue reading "ENCLOSURE SYSTEMS 9821908 CHASSIS GUIDES 600 deep for 800 deep racks (pair)"

Designation denotes configuration of adapter contacts, all adapters supplied pre-wired. ‘T’ adapters act as splitters/combiners. Terminology used in adapter descriptions: BNCF: BNC female BNCM: BNC male PHF: Phono (RCA) female PHM: Phono (RCA) male NF: N female NM: N male 83F: 83 female 83M: 83 male TNCF: TNC female TNCM: TNC male 3FX: 3 pin … Continue reading "T-ADAPTER 2BNCF-BNCM 75 ohm"

MCS-LFH – MULTICORE SPEAKER CABLE Low Fire Hazard – 2.5mm sq. conductors Two and four-core 2.5mm sq. cross section multicore cables for fixed installation loudspeaker wiring when Low Fire Hazard (‘LSOH’) designs are specified. Core pairs are colour-coded using the resistor colour code as there is no standard coding for loudspeaker cables (not mains colour … Continue reading "CANFORD MCS-LFH CABLE 2 core"

FLEXIBLE AC MAINS POWER CABLES A range of flexible mains cables with stranded conductors, all with either PVC, Arctic PVC or TRS (heat resisting rubber) jackets. Arctic grade PVC remains flexible at temperatures down to –20° C; at normal temperatures cables are very limp and flexible, but note that Arctic PVC jacketed cables are not … Continue reading "FLEXIBLE MAINS 3 core 1.5 sq.mm, Black Arctic PVC"

Green silicone sleeving, commonly used for insulating screen drain wires. Available with 3mm internal bore. Priced and sold as coils of 50 meters. 

8-position 8-wire modular plug Use with 24 - 26 AWG Shielded copper cable.

The Altusen USB CPU adapters connect KVM cables to the USB console ports of the servers. Those adapters are light and in small form factor, fit perfectly into most of the rack-mount or desktop servers.

Short Reach Style

Female XLR chassis connector 110 Ω input – female BNC 75 Ω output. Interface balanced and coaxial lines. Features & Benefits Allow long cable runs for digital audio signals via low attenuation coax lines Match balanced to coaxial lines Match impedances 110 Ω to 75 Ω Simple to use, passive units

FSJ-LFH SERIES – FOIL SCREENED STRANDED CONDUCTOR INDIVIDUALLY JACKETED MULTIPAIR CABLE Low Fire Hazard This D’n’A series (Digital and Analogue) cable is designed to be suitable for both digital and analogue audio signals, with an impedance of 100 ohms which has been proven to be suitable for AES/EBU digital audio as well as analogue microphone … Continue reading "CANFORD FSJ-LFH CABLE 12 PAIR"

KAPPE AK 50V D-SUB plastic hood• straight cable entry • 2 parts • press-fit assembly • plastic hood metallized: ABS , UL94 V-0 • jack screws 4-40 UNC Manufacturer : CONEC Factory number : 165X10949XE Package weight : 0.028 kg RoHS : conform

Extend digital signage or KVM applications with this cable. DVI-I-DL-001.5M

HST – HELICAL SCREENED STRANDED CONDUCTOR TWIN CABLE A high performance range of general purpose extra-flexible twisted twin conductor, helical (“lap”) screened cables, suitable for both microphone and general purpose uses. The cable construction design is the result of extensive research by Canford Audio, and the University of Durham Engineering Department. The outer jacket is … Continue reading "CANFORD HST CABLE 1 pair, Black"

NEUTRIK XLR PANEL CONNECTOR FEED-THROUGH ADAPTERS These feed-through 3-pin XLR adapters are mounted on a ‘D’ series mounting flange. NA3FDM has female contacts at the front and male at the rear, overall length 57mm. NA3MDF is not a wooden version, but has the standard metal construction with male contacts at the front and female at the rear, overall … Continue reading "NEUTRIK XLR NA3FDM Feed-through panel adapter, female to male"

RJ45 STRAIN RELIEF BOOTS Moulded strain relief boots with latch cover suitable for use with most RJ45 connectors. Nominal internal diameter 5.5mm (suits cables up to 6.0mm) and 6.0mm (suits cables up to 6.4mm). For Cat5E, the 5.5mm will normally be suitable, for Cat6, the 6.0mm. They are available in two formats, the standard type … Continue reading "RJ45 STRAIN RELIEF BUSH 5.5mm, flush profile, red"

Category 6 cable shall far exceed IEC 61156-5 and ANSI/TIA-568-C.2 Category 6 component standards. The conductors shall be 23 AWG construction with HDPE insulation. The copper conductors shall be twisted in pairs, separated by across divider, and all four pairs shall be covered with an overall foil and CM jacket. Download PDF file

Molded strain relief boots with latch cover suitable for use with most RJ45 connectors. Nominal internal diameter 5.5mm (suits cables up to 6.0mm) and 6.0mm (suits cables up to 6.4mm). For Cat5E, the 5.5mm will normally be suitable, for Cat6, the 6.0mm. They are available in two formats, the standard type are a soft PVC … Continue reading "RJ45 STRAIN RELIEF BUSH 6.0mm, yellow"